From: dk1machine@yahoo.com

HN003mountpad pic from cnc lathe.
Programmed using Onecnc software.

dk

Mount pad lathe part programmed with onecnc software.

Hey guys, 
Here's a pic of the parts I ran today (20pcs) with the ONecnc LATHE 2003 
generated code. This ain't rocket science, just a 1/2" radius and a 45angle. 
BUT the control is -not- conversational. I went REAL slow with fingers on 
Feedhold & Estop, and things came out right on the money. I'm not hogging 
as usual because I'm holding the blank (4.5dia X 1.275L)in a step chuck 
with a .100 deep c'bore. This took about 20 minutes from drawing profile 
to having code at the machine. It would take me 5 hours to scratch my head 
and peck out the G code coordinates for this. Cycle time is around 3Min & 15 sec.
I ain't gotta think so hard now.
This could get fun again  

dan k