Folks,

I need to sell a Vertical Mill to make room in the Playpen.  This mill is 
in good condition and has, like many mills, sits much more than it gets 
used.  Its productive life was in a machine shop around Middletown OH 
where it was used in the Tool Room.  My Price is offered at $1500.  As 
always, look it over and if interested, make an offer.

U.S. Machine Tool Co. Vertical Mill (later became US Burke)



Motor:             1 HP, 3 phase, 440/220 
                   (wired as 220 and presently under
                    power with a VFD [VFD not included] on single phase)
Table:             36" x 9 5/8"
Table Slots:       3, Standard 5/8"
X-axis Travel:     25 1/2"
X-axis backlash:   0.018, full turn 0.200" (measured in middle of travel)
Y-axis Travel:     8 5/8"
Y-axis backlash:   0.030, full turn 0.200" (measured in middle of travel)
Z-axis Travel:     16"
Z-axis backlash:   0.004, full turn 0.100" (measured in middle of travel)
Spindle:           Brown & Sharp #9
Spindle to table:  17"   

Extras
------
DRO:               Mitutoyo X-Y 
Collets(inch):     3/4,5/8,1/2(2),3/8,5/16,1/4,3/16,1/8
End Mill Holders:  3/4,5/8,1/2,3/8,3/16
Drill Adapter:     B&S #9 drawbar to Morse Taper #2

Located in Raleigh, North Carolina

- Reed
rstreift@cisco.com