FILENAMES:

Mauch2_CNCCOMP.JPG 
Mauch2_CNCDRILL.JPG 
Mauch2_MILLRACK. JPG 
Mauch2_RACK.JPG 
Mauch2_RACKMILL.JPG 

DESCRIPTION:

These are pictures of the CNC setup that Dan Mauch (dmauch@seanet.com)
uses for his mill and drill and etc.

Dan provided the following description:

>Attached are several pictures of my shop computer and CNC equipment 
>mounted on a 19" rack that is moveable on casters. I can move the computer
>and controls from, my milling machine to my homemade cnc drill press to the
>lathe or to my engraving machine.
>If you decide to set up your shop with cnc you may find that a mobile
>rack system similar to the one in my shop is the way to go. Note that 
>in addition to the video display, the computer that is a 486-66, a mouse
>with pad and a keyboard protected from chips with plastic , that I have
>two controller mounted in the rack. Above the keyboard is my 3 axis
>manual/cnc 2.5 amp 24VDC controller. It runs my mill in the manual mode for
>flycutting or single pass operation using the stepper motors as a power
>feed. The axis is selectable as well as direction and speed. With a flip of
>the switch I can shift to CNC. Below the keyboard is the Ah_HA system 6 amp
>4 axis controller. I standardized my connector so I can shift from my
>controller to the ah-ha system. The Ah_Ha system with the Artisian Software
>is really powerful.
>
>Pictures are as follows:
>
>Mauch2_CNCCOMP.JPG the cnc and computer mounted in the rack
>Mauch2_CNCDRILL.JPG my homemade CNC drill press
>Mauch2_MILLRACK. JPG a picture of my ENCO 8-36 Mill and CNC equipment
>Mauch2_RACK.JPG another picture of the rack and cnc equipment.
>Mauch2_RACKMILL.JPG another view of the mill and rack
>
>Dan