01-01-05
From:

gunner@lightspeed.net

This little dohicky followed me home just before New Years. Its 220vt, 3ph, 2hp
and both spindles are R8. Runs rather nicely though it has a few minor issues that Im
addressing at this time, mostly due to neglect and the ministrations of a hamhanded
maint department. the air fittings were used to operate a air powered fixture, and have been
removed.  This machine is about 1/2 the size of a BP, and the table is 6"x 28" aprox

Anyone have any sources for a manual?  Ive seen this badged with Yamazan, and other names. Its
apparently a knockoff of the Rockwell Horizonatl/vertical miller, or similar.

Any ideas about a R8 horizontal arbor, or should I simply make up arbor blanks and use an
1" endmill holder to hold them?  As noted, it came with a set of end mill holders.

Thanks for looking

Gunner