Machine Stand
                   Bob Harbour
                   2/2008

I built a stand for a sheet metal notcher that worked out pretty well
and the design would be extendable to other machines. The top of the
stand and shelf are 1/4" hot rolled steel, with 1/8" x 3" strip for
the legs. Two strips are welded into an L for each leg, so there are
a total of 8 strips in the legs. I put 1/8" x 1" strips along the
edges of the top and shelf spanning the legs as stiffeners.
Finally, I put 1/4" gussets as feet at the bottom of the legs to
provide some extra strength and a place to screw leveling feet into.